More Garage Time 
And a little more work...

Bonnet nose interior painted with truckbed liner...it's still wet, hence the sheen, but should transition to more satin-ish in time.

Brake line jumpers to bypass the boosters and PWDV (for now...until I replumb). Hint: use the same type of fittings across all the bits: if your junction is brass, use brass pipe fittings, if steel...use steel. Don't mix and match, especially putting harder male threaded fittings into softer female junctions. There's a lesson there for other things, I think...lol.

On to replacing the starter with the new high-torque unit I picked up from RD. I built a short jumper for the solenoid so that I could hook up a remote starter push button whilst working in the engine room to crank her over. Kind of hard to try and start from the cockpit while needing to attend to the engine directly.

Next? I think attacking the valve cover gasket, get the TDC and paint marks on the flywheel set, and installing the new Petronix dizzy, coil, fresh wiring, and new plug wires (sparkers were replaced a couple months ago) and see if that improves matters.

Ordered, from Moss, the Gunson Ezbleed kit; it's only me working in the garage (no helper, but have my phone always in my pocket Just In Case), so, thinking this will help with the bleed process in lieu of having someone to pump and release the pedal on prompting. So, will pend the final brake system attack...until it comes in.

Ordered, from AutoMat in Hicksville NY a set of loop pile (which is what's in the car already) driver and passenger side carpets for the footwell and underneath the seats. I've put down dynamat on the floor (which will attenuate the drumming of the fiberglass...yeah, a bit more weight, but that's ok) so, that should work out just fine when it comes in...

Comments

Add Comment
Fill out the form below to add your own comments.









Insert Special: