Archives
- 2023
-
2022
- June
- May
-
April
-
Starter and Timing Success
04/14/22
Got the starter in today. Whomever installed it the last time must have used an air ratchet to tighten it down...had to pull out the 24" breaker bar and 9/16ths impact impact socket to break the bottom bolt loose. It's all good now; RD had clocked the starter on the mounting flange and -
More Garage Time
04/13/22
And a little more work...
Bonnet nose interior painted with truckbed liner...it's still wet, hence the sheen, but should transition to more satin-ish in time.
Brake line jumpers to bypass the boosters and PWDV (for now...until I replumb). Hint: use the same type of fitti -
BDA Said
04/11/22
BDA (on Irwin's site) said:
"Congratulations on your progress and making your list. Have you gotten your Pertronix Ignitor (dizzy module) yet? If not, you have a choice to make: the Ignitor I can burn up if you leave your ignition on too long (I have no definition for “too long”) -
Garage Therapy Today
04/11/22
Did a bunch of stuff today..weather was springish…and calendar was empty.
1. Removed brake boosters from the engine room. Strangely, no fluid leaked out. Gave me the opportunity to put a nice heavy coat of truck bed liner paint on the sidewall to match (for lhd) the offside. Photo of -
New Parts!
04/06/22
Had the opportunity to stop by RD this morning to replenish my 'to be installed' parts stash...nice to catch up after a few years, pandemic, detour to an MGB...good to see old friends...I've been dealing with him for over 40 (!) years...and trust his insight as to what I need to have -
Front Alignment Calculator
04/05/22
I know it's a bit down the road for my ride at this point (my quick trip around the block did not reveal any steering or alignment abnormalities...yet...but Fall River MA streets are bomb-cratered, so no doubt it will happen at some point..).
Was used to using the parallel string met
-
Starter and Timing Success
- March
- February