Basically, the good book says (eliminating the stuff at the beginning...):
Raise the rear of the car and place a stand beneath each side of the chassis at the rear.
Remove the rear road wheels.
Disconnect the clutch cable from the lever at the bell housing.
Remove the silencer (muffler) assembly.
Remove the bolts securing the silencer (muffler) mounting bracket to the gearbox.
Unscrew the bolts retaining the lower suspension links to the gearbox bracket, allowing the links to drop clear.
Drive the roll pins from the inner universal joints on the transmission shafts by means of a drift (Part No. X046F6171Z)
(I have a set of roll pin drivers...)
Free the drive shafts from the gearbox output shafts by withdrawing them outwards from their splines noting the spacers and shims fitted on the output shafts.
Remove the starter motor.
Place a jack under the rear of the gearbox.
Remove the reverse indent cover.
Remove the two bolts from the rear cross member, lower the gearbox, and remove the jack.
Remove the bolts from the clutch housing, and pull the gearbox rearwards until clear of the clutch shaft.
Basically, disconnect everything, pull back. Is there enough space to pull out and back? Would seem that it's going to tilt the engine back...anything I should be aware of? Or is it just easier to go even further and drain the coolant, strip down the engine to a long block, and pull together?
Just spitballing; I like to have a strategy before diving in. (pulling the whole lump would let me attack all the aged cooling hoses, leaky gaskets and seals and clean up the back end of 50 years of spooge.
Of course, this means I would not be driving her until the end of the summer. But that's ok. I stripped down 693R and built up from a bare frame in 5 months back in 07...so, I don't waste time thinking about how long...just how well I can get the job done.
[ add comment ] ( 117 views )
<Back | 1 | 2 | 3 | 4 | 5 | Next> Last>>