Finished first carb (rear carb...the front is almost there.) New gaskets where needed, temp compensator checked and they're close, need to find proper size drift to set the butterfly shaft seals, needles set correctly, float level set for 11/16", but for now...polished (I know, geeky) the top cap...and need to set the initial settings on the bench per the manual.

Waiting for the gaskets for the base of the secondary throttle block to the head, and have new viton o-rings to set the adapter plates at the proper clearance on the secondary with new thackery washers and have ALL the proper 5/16x24 nuts and washers at the ready. New teflon-lined throttle and choke cables coming...pretty sure that snaking the new cables will be a messy exercise...but needs be done. More as it happens, stay tuned. Headed towards seeing if I can get it started this weekend or next week.

---

Comments

Fill out the form below to add your own comments.

Your Name:

Email:

URL:

Remember me:

Insert Special:
--[strong]xxx[/strong][b]xxx[/b][em]xxx[/em][i]xxx[/i] Comment:


Anti-Spam: Enter

---